Table of Contents
Advertisement
Pakninger
All maintenance and cleaning of the Aduro H1 & H3 LUX should be carried out
Med tiden bliver pakningerne slidte og bør derfor efterses. Er de utætte, bør de skiftes.
when the stove is cold, and power disconnected.
6.1 Daily maintenance – when using pellets
When you add pellets, you should brush the brazier free from of ashes and cinders. Open the door to the
combustion chamber and lift the front of the brazier (the black cast iron cone with the Aduro logo). Brush the
ashes and the cinders through the grate to the ash pan. Avoid brushing ashes and cinders down into the
pellet auger. Put back the front of the brazier.
Empty the ashpan when needed.
Brazier
We recommend two types of maintenance during the week: a short cleaning while the stove is lit (cannot last
more than 3 minutes because of the sensor in the door) and a thorough cleaning where the stove is turned
off and cold. We recommend that you conduct the short cleaning 2 times a day and the thorough cleaning
every 4 days.
During the short cleaning, the stove must be cleaned under the brazier. We recommend that you use gloves.
By using a tong or a similar tool, you can move the brazier to the side and clean out ash and cinders. Put the
brazier back in place. During the thorough cleaning, the fireproof tiles must be removed, and the auger and
the combustion chamber must be vacuumed thoroughly.
6.2 Regularly maintenance – when needed
Ashes
Empty the ashpan before it gets completely full. Always leave a layer of ashes in the stove because it
insulates and makes it easier to light a fire.
Remove the brazier and clean the top auger for ashes with a vacuum cleaner. This is done easiest by
making a "paper ring" of paper roll, which is laid around the opening of the auger. Then, press the vacuum
cleaner muzzle down towards the "paper ring" so it fits tightly. After this, the ashes can be vacuumed up.
Glass
Burning of wet wood, insufficient chimney draft and wrong use of the hybrid stove can result in soot stains on
the glass. They can easily be removed using a damp cloth that you dip in cold ash and rub on the sooty
glass. Special cleaning agents are also available to remove soot from the glass, e.g. the Aduro Easy Clean
pad. The pad neither scratches nor damages the glass, and it can be used multiple times. Water or other
cleaning agents are not necessary.
It is common maintenance to tighten the glass fittings and the hinges shortly after the stove has been
installed as well as to check if the gaskets are properly placed.
6. Maintenance of the stove
69
Advertisement
Table of Contents
