C: Errors And Malfunctions Recognized By The Computer - Fasep VIDEOTRONIC V548.G4 User Manual

Fasep 2000 srl
Videotronic V548.G4: User's Manual
C: Errors and Malfunctions recognized by the Computer
Errors may apply to some model only.
ERR 1: Shaft does not rotate
ERR 2: Rotation Direction is wrong
ERR 3: Rotation speed is not ready
ERR 4: Rotation speed is wrong (too low or too high)
ERR 5: Position Sensor or Position Disk failure
ERR 6: Safety cover is open
ERR 7: Measuring cycle was interrupted
ERR 8: Calibration weight was not inserted.
ERR 9: Activation code not correct
ERR 10: Overflow in calculations
ERR 11: Serial number is wrong
ERR 12: Serial number not inserted
ERR 13: Reserved
ERR 14: Incorrect password
ERR 15: E²prom error
ERR 16: Calibration memory error
ERR 17: Rod in incorrect position
ERR 18: Excessive weight detected
ERR 19: Hand spin interrupted
ERR 20: wrong speed due to strong deceleration
ERR 21: Error in inputting data
ERR 22: Brake error
ERR 23: Reserved
ERR 24: PL shaft open
ERR 25: Reserved
ERR 31: Activation code not valid
ERR 32: Service Warning / Lock
ERR 33: Calibration check out of range
ERR 34: Input gauge not in home position
ERR 35: Width Input gauge not in home position
ERR 37: 1137 board not found (formerly numbered Error 35)
ERR 42: Can not back up or restore 27C16 memory information
ERR 46: Memory not Found (Start of the program that fails to read or write to memory, both in 24C16 and 1150 modes)
19
Rev. 1.6
15 April 2019