Barbecook EDSON BC-CHA-1020 Manual page 7

8.5 Maintaining enamel, stainless steel,
chrome and powder coated parts
The appliance is composed of enamelled, stainless steel,
chromed and powder coated parts. Each material has to be
Material How to maintain this material
• Do not use sharp objects and do not knock
Enamel
against a hard surface.
• Avoid contact with cold liquids while still hot.
• You can use metal sponges and abrasive
detergents.
• Do not use aggressive, abrasive or metal
Stainless steel
detergents.
and chrome
• Use soft detergents and let them act on the
steel.
• Use a soft sponge or cloth.
• Rinse thoroughly after cleaning and dry well
before storing.
• Do not use sharp objects. Use soft detergents
Powder
and a soft sponge or cloth.
coated
• Rinse thoroughly after cleaning and dry well
before storing.
Damages caused by not following these instructions are
regarded as inadequate maintenance and are not
covered by the warranty.
Below the exploded view of your appliance (second part of the
of each part, so you can use it to check how you have to maintain
a particular part. The parts list uses the following symbols:
Symbol
Enamel
Chrome
Stainless steel
Powder coated
8.6 Ordering spare parts
1
If you registered your appliance online, you will
automatically be guided to the correct list in your
MyBarbecook account. There you have the possibility
to order your parts online.
2 Order the spare part via www.barbecook.com or at your
point of sale. Parts under warranty can only be ordered
at your point of sale.
Material
www.barbecook.com
9 WARRANTY
9.1 Covered
Your appliance comes with a warranty of two years, starting from
the date of purchase. This warranty covers all manufacturing
defects, provided that:
• You used, assembled and maintained your appliance
according to the instructions in this manual. Damages
caused by misuse, incorrect assembly or inadequate
maintenance are not regarded as manufacturing defects.
• You can present the receipt of your appliance.
• The Barbecook quality departme
are defective and that they proved defective under normal
use, correct assembly and adequate maintenance.
If one of the above conditions is not met, you cannot claim any
form of contribution. In all cases, the warranty is limited to the
repair or replacement of the defective part(s).
9.2 Not covered
The following damages and defects are not covered by the
warranty:
• Normal wear and tear (rusting, distortion, discolouration...) of
normal to replace these parts from time to time.
• Visual irregularities that are inherent to the manufacturing
process. These irregularities are not regarded as
manufacturing defects.
• All damages caused by inadequate maintenance, incorrect
storage, improper assembly
pre-assembled parts.
• All damages caused by misuse and abuse of the appliance
(not using it according to the instructions in this manual,
using it for commercial purposes...).
• All consequential damages caused by careless or
non-compliant use of the appliance.
•
of aggressive detergents, exposure to chlorine... These
damages are not regarded as manufacturing defects.
7