Makita 2414B Instruction Manual page 8

1. When cutting thick pipes or bars
Move the handle back and forth to slide the tool head.
This will help increase cutting sufficiency and prevent
wheel loading.
A
► 1. Handle
B
► 1. Handle
C
► 1. Handle
Fig. A ; For tools with full type lower safety guard
Fig. B ; For tools with half type lower safety guard
Fig. C ; For tools with center cover/center cap
2. When cutting channels or angles
If a portion of the workpiece near you is left uncut, pull
the handle. The tool head slides back and the wheel
cuts the remaining uncut portion. If the uncut portion
cannot be cut even by using this method, use a spacer
block as explained above.
A
1
► 1. Uncut portion 2. Workpiece
1
► 1. Uncut portion 2. Workpiece
1
► 1. Uncut portion 2. Workpiece
Fig. A ; For tools with full type lower safety guard
Fig. B ; For tools with half type lower safety guard
Fig. C ; For tools with center cover/center cap
8 ENGLISH
1
B
1
C
2
2
1 2