Power Connector Cable - HP ProBook 450 G10 Maintenance And Service Manual

2. Lift the speakers straight up to remove them (2).
To install the speakers, reverse this procedure.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 6-10 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the power connector cable:
1. Move the antenna cables (1) that route over the right screw.
2. Remove the three Phillips M2.5 × 4.0 screws (2) that secure the right display hinge to the computer,
and then rotate the hinge off the power connector (3).
3. Disconnect the cable from the system board (4).
58 Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page 37).
Spare part number
M21725-001
Battery on page 46).
37).