Face-Up/Down Din Rail Mounting; Removing The Au910/Au912 From The Din Rail; Grounding The Au910/Au912 - LGX Extended Temperature AU910 User Manual

3.5.2 Face-Up/Down DIN Rail Mounting

1. For panel face-up/down mounting, please secure the two DIN rail clips to
the DIN rail bracket according to the illustration.
System mounted on the DIN rail
Installation and Maintenance
2. Position the bracket side of the unit
directly in front of the DIN rail. Make
sure the top of the DIN rail clip hooks
over the top of the DIN rail.
- 44 -
Installation and Maintenance

3.5.3 Removing the AU910/AU912 from the DIN Rail

1. Make sure that power is removed from the computer, and disconnect all
cables from the computer.
2. Hold the unit in both hands and push downwards. As the clip releases, lift
the bottom slightly.

3.6 Grounding the AU910/AU912

Follow the instructions below to ground the computer on the ground. Make
sure to follow any grounding requirements at your site.
Warning When installing the unit, the ground connection must always
be made first and disconnected last.
1. As the figure illustrates above, remove
the ground screw located on the bottom left
of the rear panel.
2. Attach the ground wire to the rear panel
with the screw.
- 45 -