1.8.2 Serial Ports (COM1 ~4)
Both AU910 and AU912 are built with integrated serial ports that combine
COM1 ~ COM4 into a D-sub 44-pin female connector. Each port supports
RS-232; in addition, COM3, 4 supports RS-232/485 selectable.
To connect to any serial device, follow the steps below:
1. Turn off the system and the serial devices.
2. Attach the interface cable of the serial device to the serial connector.
Be sure to fasten the retaining screws.
3. Turn on the computer and the attached serial devices.
4. Refer to the serial device's manual for instructions to configure the
operating environment to recognize the new attached devices.
5. If the serial device needs specified IRQ or address, you may need to
run the CMOS setup to change the hardware device setup.
AU910
Ant.
Optional
+
-
COM1~COM4
SW
DC IN
10V~28V
AU912
Ant.
Optional
+
-
COM1~COM4
SW
DC IN
10V~28V
General Information
DisplayPort
DisplayPort
- 10 -
General Information
1.8.3 LAN Ports
Both AU910 and AU912 provide two Intel® WG82574IT 10/100/1000 Base-T
Ethernet (RJ45) ports. For network connection, follow the instructions below:
1. Turn off the system and the Ethernet hubs.
2. Plug in one end of a 10/100/1000Base-T hub cable to the system's
RJ45 jack.
AU910
Ant.
Optional
+
-
COM1~COM4
SW
DC IN
10V~28V
AU912
Ant.
Optional
+
-
COM1~COM4
SW
DC IN
10V~28V
DisplayPort
DisplayPort
- 11 -