Advertisement
Others
STANDBY
Sends the power off command. Or when the power is turned
off using the infrared remote commander, the camera
becomes STANDBY state.
In the STANDBY state, the camera can accept only the
VISCA Commands and the POWER ON of the infrared
remote commander, and the video signal output and other
operations are stopped.
I/F Clear
Clears the Command buffer of the camera. The buffer is
cleared even during the power on state using the control
software.
Memory (Preset)
Using the preset function, 256 sets of camera shooting
conditions can be stored and recalled.
This function allows you to achieve the desired status
instantly, even without adjusting the following items
each time.
• Pan/Tilt Position
• Zoom Position
• Digital Zoom On/Off
• Focus Auto/Manual
• Focus Position
• AE Mode
• Shutter control parameters
• Bright Control
• Iris control parameters
• Gain control parameters
• Exposure Compensation On/Off
• Exposure Level
• Backlight Compensation On/Off
• Auto Slow Shutter On/Off
• White Balance Mode
• R/B Gain
• Aperture Control
• ICR On/Off
• WD Parameter
• Defog On/Off
The settings stored using this function are recalled
when the power is turned on.
For setting items, see the "Initial Settings and Preset"
section on page 10.
Note
Rewriting of memory is not unlimited. Be careful to avoid using the
memory area for such as unnecessary tasks as rewriting the
contents of the memory for every operation.
Advertisement
