Thetford SCK12 Series User And Installation Instructions Manual page 15

INSTALLATION
The Ø8mm gas inlet is located to the rear of the appliance. Prior to connection remove the
plastic protection plug from the fitting. The appliance must be connected using metal pipe
manufactured from either copper, seam welded steel, seamless steel or stainless steel, which
complies with the requirements of EN1949. Rubber tubing shall not be used.
Electrical Connection
Spark Ignition (12V DC)
The spark ignition generator must be connected to a suitable 12V DC supply.
Use sheathed spade connectors to connect the generator to the 12V power supply.
Dual Fuel Models (230-240V ~ 50Hz)
Models fitted with power cord only
This appliance is supplied with a double insulated cord, type 227 IEC 53, HO5V V-F, which is
suitable for use up to 4 amps. This should be connected to a double pole switched mains
supply, with 3mm minimum contact separation at all poles in accordance with the wiring rules.
Ensure that all electrical cables and wires are routed well clear of any heat source, including
this appliance. Do not allow the cord to hang loose into the lower compartment. The switch
must be accessible after installation.
Models fitted with plug and power cord (UK only)
This appliance is supplied with a plug attached to the end of the power cord, for connection to
a switched wall mounted socket. After connection ensure the power cord and any other
electrical wires are routed well clear of any heat source, including this appliance. Do not allow
the cord to hang loose into the lower compartment. The switched socket must be accessible
after installation.
• This appliance must be earthed
• After installation the appliance must be tested for soundness
• The gas supply input pressure to which this appliance is connected must
When installing, to avoid damage DO NOT lift the appliance using the door
not rise or fall by more than 2.5mbar (butane/propane) from nominal
when all appliances connected to the supply are operated
simultaneously. If this appliance is not installed in accordance with the
instructions and tolerances detailed herein, the manufacturer cannot be
held responsible for any problems that occur, or poor performance that is
perceived/witnessed.
Seek assistance and support the underside of the appliance.
WARNING – Heavy Product.
handles.
15