Page 1
FOR USE IN GB, CH, ES, PT, IT, BE, FR, IE, DK, FI, GR, NL, NO, DE, SE THETFORD LIMITED, Unit 19, Oakham Drive, Parkwood Industrial Estate Rutland Road, Sheffield S3 9QY, ENGLAND. TEL: + 44 (0) 114 273 8157...
Page 4
INTRODUCTION This appliance is designed for cooking food, any other use is incorrect and dangerous. Failure to install the appliance correctly, or improper use, could invalidate any warranty or liability claims and lead to prosecution. This appliance must be installed in accordance with the local, national and European regulations in force.
OPERATION • The grill area can get hot when the oven is in use, even if the grill is switched off. • Care should be taken when removing pans from the grill, i.e. use of oven gloves, and by making use of the removal grill pan handle. Using the Grill Ensure gas cylinder/supply is connected and turned on.
Page 6
OPERATION Using the Oven Ensure gas cylinder/supply is connected and turned on. In the event of a gas smell turn off at gas cylinder/mains and contact supplier. To light: Open door, push in the control knob and turn to full rate (Gas Mark 9, 240° C). Hold a lighted match or taper to the burner and push the control knob in and hold.
Page 7
OPERATION • When cooking, young children should be kept away. • The pans and trays supplied with this appliance are the maximum sizes recommended for use. Larger pans and trays may restrict good circulation of heat, increasing cooking times. • Always ensure food is properly cooked prior to serving. Temperature Dish Mark...
INSTALLATION Regulations And Standards In your own interest of safety, it is law that all gas appliances are installed and serviced by an approved competent person, in accordance with the local and National/European standards in force Failure to install the appliance correctly could invalidate any warranty or liability claims and lead to prosecution.
INSTALLATION Gas Connection Prior to connection ensure the local conditions for gas type and gas pressure match the appliance specification. (Gas type and pressure for this appliance are printed on the databadge located on the base of appliance) The Ø8mm gas inlet is located to the rear of the appliance. Prior to connection remove the plastic protection plug from the fitting.