General Assembly Instructions - Vacmaster VBV1210 Operator's Manual

GENERAL ASSEMBLY INSTRUCTIONS

A Phillips head screwdriver is required.
2
7 8
12 13
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the powerhead off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed
on page 7 (Fig. 4).
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws (Fig. 5).
to page 13 for installation instructions (Fig. 6 & 7).
to damage the bag. Dust collection bag sold separately. For installation instructions, see page
14 (Fig. 8).
9. Place the powerhead back on the collection tank, aligning the top section with the latches, and
snap into place. Keep in mind to position the powerhead so that the blower port is towards the
rear (Fig. 10).
10. Insert the locking end of the hose into the vacuum port on the collection tank and turn to lock
into place (Fig. 11).
11. Choose the desired accessory and insert onto the end of the hose or extension wand
(Fig. 12).
NOISE DIFFUSER
For quiet operation during vacuuming, install the noise diffuser into the blower port by inserting the
locking end of the diffuser into the blower port and turning clockwise to lock into place (Fig. 13).
3
1
2
9
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
4 5
10
11
8
6