Exmark Lazer LZE Operator's Manual page 79

Problem
Blades do not rotate.
Clutch will not engage.
Deck will not raise or lower.
Possible Cause
1. Deck belt is worn, loose or broken.
2. Deck belt is off pulley.
3. Broken or missing idler spring.
4. Drive belt not routed correctly.
1. Fuse is blown.
2. Low voltage supply at the clutch.
3. Damaged coil.
4. Inadequate current supply.
5. Rotor/armature airgap is too large.
6. Wing deck interlock.
1. Operator not in seat.
2. Key not in "RUN" position.
3. Low fluid level.
79
Troubleshooting
Corrective Action
1. Install new deck belt.
2. Install belt on clutch and deck pulleys,
idlers, and tensioning idler per routing
decal on deck.
3. Replace the spring.
4. Refer to belt routing decal on deck.
1. Replace fuse. Check coil resistance,
battery charge, charging system, and
wiring connections and replace if
necessary.
2. Check coil resistance, battery charge,
charging system, and wiring connections
and replace if necessary.
3. Replace clutch.
4. Repair or replace clutch lead wire or
electrical system. Clean connector
contacts.
5. Remove shim or replace clutch.
6. Lower deck and fully unfold wings.
1. Operator sit in seat.
2. Turn key to "RUN" position.
3. Check fluid level.