Check Tire Pressures; Check Condition Of Belts; Lubricate Grease Fittings - Exmark Lazer LZE Operator's Manual

1. Stop engine and wait for all moving parts to stop.
Engage parking brake.
2. Wait until the machine cools before checking the
hydraulic oil.
3. Adjust the seat to the most forward position to
access the caps on the LH and RH hydro drives.
4. Clean the area around hydraulic reservoir cap and
remove cap.
5. Wipe the dipstick clean and re-insert the cap back
into the hydro. Lightly tighten the cap.
6. Remove the cap again and check the level of the
oil on the dipstick. See Figure 45 for oil levels.
1. Full
Note: The oil level on the dipstick will be
incorrect if the oil is checked when the unit is hot.
7. If the dipstick oil level is at the "add" mark add
Exmark Premium Hydro Oil.
8. Replace hydraulic reservoir cap and tighten until
snug. Do Not overtighten.

Check Tire Pressures

Service Interval: Every 50 hours
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Check tire pressure in drive tires and pneumatic
casters.
3. Inflate pneumatic casters to 13 psi (90 kPa).
Inflate drive tires:
Figure 45
2. Add
• All Models Except Wing Deck Models: 13
psi (90 kPa)
• Wing Deck Models: 18 psi (124 kPa)
4. Semi-pneumatic caster tires Do Not need to be
inflated.
Note: Do Not add any type of tire liner or foam
fill material to the tires. Excessive loads created by
foam filled tires may cause failures to the hydro drive
system, frame, and other components. Foam filling
tires will void the warranty.

Check Condition Of Belts

Service Interval: Every 50 hours
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Remove left and right belt shields on deck and lift
up floor pan to inspect deck drive belt.
3. Check under machine to inspect the pump drive
belt.
Note: No adjustments are required for belt
tension.

Lubricate Grease Fittings

g008606
Note: See chart for service intervals.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Lubricate fittings with one to two pumps of
NLGI grade #2 multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
All Models Except Wing Deck Models
Fitting
Locations
1. Deck and
Pump Idler
Pivots
2. Front
Caster
Pivots
63
Maintenance
Lubrication Chart
Initial Number of
Pumps Places
1 2
*0 2
Service
Interval
Yearly
*Yearly