Clear Counter Heads - SATO CL608 Service Manual

7-4 Clear Counter Heads

STEP PROCEDURE
1. Record all current dip switch positions, then place all switches in the OFF
position.
2. Place the DSW2-5 in the ON or up position.
3. Place the print head in the open position. Keeping both the LINE and
FEED keys depressed, power on the printer.
4. Upon hearing the audible tone, release the LINE and FEED keys. Place
the print head back in the closed position and DSW2-5 in the OFF or
down position.
5. Verify display: "FACTORY MODE".
6. Press the FEED button once. Verify display: "COUNTER CLEAR NON".
7. Press the LINE button twice. Verify display: "COUNTER CLEAR HEAD".
8. Press FEED button to initialize reset. After a slight pause, (1) blank label
will feed out followed by a factory test print.
9. Place the printers power switch to the OFF position and return all switches
to their original positions.
Page 7-4
SECTION 7 – Factory Resets
Warning: This test activates all the heating elements on the
print head and therefore should be used for testing purposes
only with full width labels to avoid damaging the print head.
SATO CL608 & CL612 SERVICE MANUAL
FACTORY MODE
COUNTER cLEAR
NON HEAD
COUNTER CLEAR
HEAD
Rev. B Jan. 2000
PN 9001024