Serial (Modbus Rtu); Vnc Account - Emerson VILTER MicroVission Operation And Service Manual

Section 12 • Configuration Screen
• Protocol: Drop-down box to select the type of pro-
tocol used to remotely control the MicroVission.
Available options are "Modbus TCP" and "Ethernet
IP".
• Node Address: Address used by the MicroVission
when communicating with multiple panels.

Serial (Modbus RTU)

This checkbox when selected, enables the Serial Modbus
RTU port. Other settings will be allowed for selection
when this option is enabled.
• Node Address: Address used by the MicroVission
when communicating with multiple panels.
• Port: The MicroVission has two ways to communi-
cate on serial bus, either via the in-built serial port
P12/RS485 or through the USB port. This drop-
down box allows the operator to choose which one
will be used.
• Baud Rate: Sets the baud rate for the serial
communication.
• Data Bits: Fixed at 8 Data bits.
• Stop Bits: Identifies the end of character for
re-synchronizing.
• Parity: Identifies the type of error detection.
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3
Figure 12-3. Configuration Screen - Communication

VNC Account

MicroVission panels can be accessed remotely by using a
VNC client over TCP/ IP network. This section allows the
operator to change default VNC password and VNC port
number. For more information, see Figure 12-3.
• New Password: The operator will add the password
by touching the entry box and typing the password
via the pop-up keyboard.
• Verify New Password: The operator will re-enter the
password by touching the entry box and typing the
password via the pop-up keyboard.
• Port Number: The operator will change the port
number for the VNC server by touching the entry
box and typing the port number via pop-up keypad.
Default port number is 5900. The operator can assign
the port number in the range from 5900 to 6000.
12 – 7