Lenovo ThinkSystem SR645 Maintenance Manual page 136

Step 3. Install the drive in the drive bay.
Figure 46. Hot-swap drive installation
a. Ensure that the drive tray handle is in the open position. Slide the drive into the drive bay until it
snaps into position.
b. Close the drive tray handle to lock the drive in place.
Step 4. Check the drive LEDs to verify that the drive is operating correctly. For details, see Drive LEDs.
Step 5. Continue to install additional hot-swap drives if necessary.
After you finish
1. Reinstall the security bezel if you have removed it. See Install the security bezel.
2. Use the Lenovo XClarity Provisioning Manager V3 to configure the RAID if necessary. For more
information, see:
https://sysmgt.lenovofiles.com/help/topic/LXPMv3/LXPMv3_introduction.html
ThinkSystem SR645 Maintenance Manual
126