Table of Contents
Advertisement
An isolating switch must be integrated into the perman-
ent electrical installation according to the installation
regulations.
Identify the phase and neutral conductors in the
1.
socket.
The appliance may be damaged if it is not connec-
ted correctly.
Connect the hob in accordance with the connection
2.
diagram.
See the rating plate for the voltage.
Connect the wires of the mains power cable accord-
3.
ing to the colour coding:
Green/yellow = Protective conductor
‒
Blue = Neutral conductor
‒
Brown = Phase (external conductor)
‒
24.6 Appliance combinations
When combining with other appliances, note the follow-
ing.
Only fit the appliance above a ventilated oven from the
same manufacturer. If you want to install the appliance
next to an oven, the handles of both appliances must
be located in the centre. Installation above a refriger-
ator is possible.
24.7 Combination with a warming drawer
First fit the warming drawer. Follow the installation in-
structions for the warming drawer.
Slide the appliance, on the warming drawer, into the fit-
ted cabinet. When sliding in the appliance, do not dam-
age the warming drawer's panel.
24.8 Installation in a tall unit
Observe the installation dimensions and the safety
clearances in a tall unit.
To ventilate the appliance, the intermediate floor must
have a ventilation cut-out.
Dimensions for appliances with a width of 752 cm:
If the tall unit has another back panel in addition to the
element back panels, this must be removed.
Do not fit the appliance too high up; it must be pos-
sible for accessories to be removed easily.
24.9 Corner installation
Observe the installation dimensions and the safety
clearances when installing in a corner.
To ensure that the appliance door can be opened, you
must take the minimum dimensions into consideration
when installing in a corner.
24.10 Installing the appliance
ATTENTION!
Carrying the appliance by the door handle could break
it. The door handle cannot support the weight of the
appliance.
Do not carry or hold the appliance by the door
▶
handle.
The control panel may be damaged by setting it down
on the floor.
Never place appliances on the floor with the control
▶
panel at the bottom. Underlay with wooden strips.
Never raise appliances sloping from the rear with
▶
the control panel at the bottom.
Push the appliance in fully.
1.
Do not kink or trap the connection cable, or route it
over sharp edges.
Align the appliance horizontally and centrally.
2.
Use a spirit level to adjust the appliance so that it is
3.
perfectly level.
Installation instructions en
39
Advertisement
Table of Contents
