Table of Contents
Advertisement
Fault
The appliance is not working.
Appliance does not start.
Food takes longer than usual to
heat up.
Appliance is switched on but
controls not responding;
pears on the display.
The appliance is not heating and
appears on the display.
The interior lighting is not work-
ing.
20.2 Information on display panel
Fault
The display shows the error mes-
sage "Exxx"
20.3 Power cut
Your appliance can bridge a power cut of a few
seconds. The operation continues.
If the power cut lasts longer and the appliance was op-
erating, the display shows a message. The operation is
interrupted. After the power cut, you can start up the
21
Disposal
21.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Dispose of the appliance in an environmentally
▶
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
Cause and troubleshooting
Malfunction
Switch off the fuse in the fuse box.
1.
Switch the fuse on after appox. 10 seconds.
2.
If the malfunction occurs again, call customer service.
3.
Appliance door not fully closed.
Close appliance door.
▶
The microwave power setting is set too low.
Set a higher microwave output setting.
▶
→ "Microwave", Page 11
A larger amount than usual has been placed in the appliance.
Set a longer cooking time.
▶
You need double the time when you have double the amount.
The food is colder than usual.
Turn or stir the food from time to time during cooking.
▶
Childproof lock is activated.
ap-
Deactivate the childproof lock.
▶
→ "Deactivating the childproof lock", Page 19
Demo mode is activated.
Deactivate demo mode.
▶
→ "Basic settings", Page 19
The halogen bulb is defective.
Change the cooking compartment bulb.
▶
→ "Replacing the cooking compartment bulb", Page 23
You can obtain a new halogen bulb from our customer service or specialist
retailers.
→ "Customer Service", Page 26
Cause and troubleshooting
An error has occurred.
Switch the appliance off and on again.
1.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the
2.
exact error message when calling.
→ "Customer Service", Page 26
appliance as usual. To do so, turn the function selector
to the zero position.
→ "Initial start-up", Page 10
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Disposal en
25
Advertisement
Table of Contents
