Sekonic LITEMASTER PRO L-478 Series Operating Manual page 68

Find Quality Products Online at:
Condition Possible reasons
Can't use the The memory function can't be used in the
memory following measuring modes.
- Cord multiple (cumulative) flash mode
- Cordless multiple (cumulative) flash mode
- Radio triggering multiple (cumulative) flash
mode
- Illuminance/luminance measuring mode
Is "Memory Full" displayed when you press
the memory button? The memory can be
used 9 times.
The EV The EV value is displayed in the following
value isn't measuring modes.
displayed. - Ambient T priority mode
- Ambient F priority mode
- Ambient TF priority mode
- Ambient HD cine mode
- Ambient cine mode
The EV scale The EV scale can't be displayed in the
isn't displayed following measuring modes.
even though it - Cord multiple (cumulative) flash mode
is selected. - Cordless multiple (cumulative) flash mode
- Radio triggering multiple (cumulative) flash
mode
Flash does not Is the radio receiver in the flash compatible
trigger even with the meter's transmitter. That is, is the
when radio receiver made by PocketWizard, Elinchrom,
triggering or Phottix Strato II.
mode is set.
Are the meter transmitter and receiver set for
the same channel number?
<Elinchrom>
Are the meter and receiver both set for
Normal or Speed Mode?
<PocketWizard>
Are the meter and receiver set for the same
ControlTL and/or Standard Channel and
Zone?
<PocketWizard>
Are the meter transmitter and receiver set for
the same frequency?
<Phottix>
Are the receivers Strato II compatible?
Error 10 is Did you turn the power supply off or remove
displayed. the USB cable while updating the firmware
on the data transfer software "Update"
screen?
GlobalTestSupply
www.
What to do
Use the memory function in modes other than
those on the left.
If you can't put the 10 or later measured value
th
into the memory, clear unnecessary memory
values on the memory clear screen, and then
measure and store the value again.
Use a measuring mode which displays the
EV value.
Use the EV scale in a flash mode other than
a cumulative mode. The measuring value
scale (f-stop value) can be used in cumulative
modes.
Use a receiver which has the same radio wave
system.
Elinchrom: www.elinchrom.com
PocketWizard: www.pocketwizard.com
Phottix: www.phottix.com
Set the same channel number and group
number on the transmitter and receiver.
Check that the transmitter and receiver are
both set to the same mode (either the normal
mode or speed mode).
Check that the transmitter and receiver are
both set to the same system (either the
standard system or ControlTL system).
As there are two types of frequency (FCC&IC
(344 MHz band) and CE (433 MHz band)),
ensure that the transmitter and frequency have
the same specifications (frequency).
The meter includes Strato II only. Indra and
Mitros+ flashes can be set to receive Strato II
transmission.
Overwrite the firmware on the data transfer
software "Update" screen.
68
.com
sales@GlobalTestSupply.com