Vents-us TwinFresh Expert RW1-50 V.2 User Manual page 13

Prior to operating the ventilator set it up using the DIP switch. It is located on the controller circuit board. To access the DIP switch, take
off the front panel of the indoor unit and uplift the rubber plug that covers the switch.
OFF - master unit (hereinafter referred to as
ON - slave unit (hereinafter referred to as
OFF - the ventilator is switched off in the Standby mode.
ON - the ventilator operates at Speed I in the Standby mode.
Adjusting the airflow direction of the TwinFresh Expert in Ventilation mode
OFF - operation in air extraction mode.
ON - operation in air supply mode.
Setting the Boost mode (when any of the sensors is triggered) for the TwinFresh Expert Duo model
OFF - when the sensor is triggered, the fan operates in the exhaust mode at the third speed.
ON - if the sensor is triggered, the fan operates in the current mode at the third speed.
OFF – standard operation of the unit.
ON - restore factory default settings. For this purpose, move the switch on the operating ventilator to the ON position,
after the sound signal turn the switch to the OFF position.
www.vents-us.com
PRE-SETTING OF THE VENTILATOR
POSITIONING OF THE DIP SWITCHES
Defining the role of the ventilator when operating in a group
"Master
"Slave
Standby mode setup
and when working as part of a group
Restore factory default settings
DIP switch and USB
connector under
the cover
unit")
unit")
13