Installing Optional Auxiliary Power Remote Panel - Miller EnPak A30 GBW Owner's Manual

5-4. Installing Optional Auxiliary Power Remote Panel

2
3 in. (76.2 mm)
7
8
OM-283757 Page 26
.
A complete Parts List is available at www.MillerWelds.com
1
3
7-5/8 in.
(194 mm)
5
4
9
10
11
1 Auxiliary Power Remote Panel-
Front
2 Auxiliary Power Remote Panel -
Rear
3 Mounting Holes
4 Strain Relief
5 Plug
6 Ground Stud
7 Black Lead
8 Brown Lead
9 Blue Lead
10 Green Lead
11 Outer Strain Relief Nut
Remove front cover of remote panel.
Mount panel by installing bolts through
four mounting holes. Hardware is cus-
tomer supplied.
Strain relief and cable may be routed
through rear of panel instead of through
the bottom. To change the configuration,
follow these steps:
Remove front cover.
Remove brown and black leads from the
circuit breakers. Remove the blue lead
from the 120 V receptacle. Remove the
green ground lead from the ground stud.
Remove leads from strain relief by remov-
ing outer strain relief nut.
Remove plug from back hole. Remove
strain relief from bottom of remote box.
Install strain relief in back hole of remote
box.
Install plug in bottom hole of remote.
Route leads through strain relief and re-
connect according to the diagram shown
below. Verify cable insulation extends
through strain relief. Then tighten outer
6
strain relief nut until cable does not move
in strain relief.
.
Optional rear cable
exit shown.
301511 / 284174