Saxby Lighting EL-40094 Instruction Leaflet

Commissioning
• Place the fitting over the back plate, ensuring that the
bolts in the back plate are aligned with the holes in the
front of the fitting. Replace the domed nuts/ washers to
secure the fitting. Do not over tighten.
Fitting/replacing bulbs
When changing a bulb, always switch off at the mains and
allow the bulb to cool before handling. Dispose of used
bulbs carefully. Do not exceed the wattage stated or use a
different shape bulb from that indicated on the fitting.
Use a soft cloth to handle bulbs, avoid directly touching the
bulbs as this will shorten their life.
Care and Cleaning
Do not use solvents or abrasive cleaners as these could
damage the finish.
In normal circumstances, stainless steel is very resistant to
corrosion. It does however require maintenance to preserve
the high quality appearance. Wash the product with warm
soapy water, removing all surface deposits. Rinse with clear
water and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after installation.
This is normally caused by tiny iron particles left behind
after the brushing process when finishing.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This bulb is protected by a shade. This part must be replaced immediately should the shade become
cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked
Shade
www.saxbylighting.com
• Fit the bulb into the lamp holder, and refit the bulb cover.
• Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
35W GU10
Mains Halogen
Wash and dry as detailed above. Then with a soft cloth
soaked with a protective oil, wipe all over.
However if the product is subject to extreme environmental
conditions such as marine locations, industrial pollution
and acid rain these maintenance procedures should be
carried out around four times a year. For severe corrosion,
non-abrasive cream cleaners or proprietary stainless steel
cleaners should be used to remove the corrosion. Wash and
dry as detailed above. Then with a soft cloth soaked with a
protective oil, wipe all over.
Do not clean the units with a pressure washer.
Iss.2 24092015
Saxby Lighting Ltd. LS9 0SE
Instruction leaflet
Canon Wall
EL-40094