Saxby Lighting Severus EL-40105 Instruction Leaflet

Commissioning

• When complete, wrap the terminal block in 2 layers of
good quality insulation tape.
• Place the lens housing back onto the wall plate, making
sure that no cables are trapped or exposed and secure
with the 4 screws removed previously. Push the cover
plate – removed previously – onto the led housing unit.

Fitting/Replacing bulbs

• The LED module in this product is non replaceable
We recommend cleaning with a soft dry cloth.

Recycling advice

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.

Safety information

For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
This light source is protected by a shade. This part must be replaced immediately should the shade
become cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked Shade
www.saxbylighting.com
• Replace fuse or circuit breaker and switch on. Your light
is now ready for use.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Iss.2 20112015
Saxby Lighting Ltd. LS9 0SE
Instruction leaflet
Severus Outdoor Wall
EL-40105