Appendices; Appendix A: Technical Support; Appendix E: Compliance Information; Safe Use And Installation Instructions - Onlogic Axial AC101 Product Manual

9 - Appendices

9.1 - Appendix A: Technical Support

Additional technical support and information can be found on our support website at the following
link:
https://support.onlogic.com/documentation/

9.2 - Appendix E: Compliance Information

Do not open or modify the device. The device uses components that comply with FCC and CE
regulations. Modification of the device may void these certifications.

9.2.1 - Safe use and installation instructions

1. Install the device securely. Be careful handling the device to prevent injury and do not drop.
2. Equipment is intended for installation in a Restricted Access Area.
3. Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater than room ambient. Therefore,
consideration should be given to installing the equipment in an environment compatible with
the maximum ambient temperature (Tma) specified by the manufacturer.
4. Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of
air flow required for safe operation of the equipment is not compromised.
5. Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous
condition is not achieved due to uneven mechanical loading.
6. Circuit Overloading - Consideration should be given to the connection of the equipment to the
supply circuit and the effect that overloading of the circuits might have on overcurrent
protection and supply wiring. Appropriate consideration of equipment nameplate ratings
should be used when addressing this concern.
7. Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct connections to
the branch circuit (e.g. use of power strips).
8. Ambient operating temperature must be between 5 °C to 40 °C with a non-condensing relative
humidity of 8-85%.
9. The device can be stored at temperatures between -40 °C to 70 °C.
10. Keep the device away from liquids and flammable materials.
11. Do not clean the device with liquids. The chassis can be cleaned with a cloth.
12. Allow at least 2 inches of space around all sides of the device for proper cooling. If the device
is mounted to a vertical surface then recommended device orientation is so that heatsink fins
allow air to rise unobstructed. Alternative orientations may result in reduced operational
temperature range.
13. This device is intended for indoor operation only.
14. Install the device only with shielded network cables.
15. Service and repair of the device must be done by qualified service personnel. This includes,
but is not limited to, replacement of the CMOS battery. Replacement CMOS battery must be
of the same type as the original.
16. Proper disposal of CMOS battery must comply with local governance.
17. Product must only be connected to a certified router, switch or similar network equipment.
18. Product is intended for indoor use only.
19. Product cannot be connected to the public network.
39