Power; Supported Power Supplies; Power Redundancy - Onlogic Axial AC101 Product Manual

5 - Power

The sections below focus on the power features and capabilities of the Axial AC101 Edge Server.

5.1 - Supported Power Supplies

The system supports two redundant power supplies, which may either be 450W or 750W. These
power supplies are hot-swappable, meaning they can be replaced while the system is running without
interrupting its operation.
It is important to note that the two power supplies must be of the same wattage. Mixing power
supplies of different wattages is not allowed. Please ensure that both power supplies are of the same
wattage before installing them into the system.
If you need to replace a failed power supply, simply remove the failed unit and insert a new one of the
same wattage. The system will automatically recognize the replacement power supply and bring it
online to restore redundancy.

5.2 - Power Redundancy

The power supplies in this system are fully redundant in a primary/backup mode. This means that the
two power supplies work in parallel, with one power supply acting as the primary source of power and
the other as a backup.
In normal operation, the primary power supply is responsible for supplying power to the system, while
the backup power supply remains idle. If the primary power supply fails, the backup power supply
automatically takes over, ensuring that the system continues to receive power without interruption.
The power supplies are designed to work seamlessly together, with the primary power supply
handling the majority of the load and the backup power supply providing additional power as needed.
31