Loading The Racks - IKEA RENGORA Instruction Manual

ENGLISH
5. SANITIZING - Normally or heavily soiled crockery, with additional antibacterial wash. Can be used to perform maintenance of the
dishwasher.
6. PRE-WASH - Use to refresh crockery planned to be washed later. No detergent to be used with this program.
7. SELF-CLEAN - Program to be used to perform maintenance of the dishwasher, to be carried out only when the dishwasher is EMPTY using
specific detergents designed for dishwasher maintenance.
Modifying a running program
If a wrong program was selected, it is possible to change it, provided that it has only just begun: open the door, press and hold the ON/OFF
button, the machine will switch off. Switch the machine back on using the ON/OFF button and select the new wash cycle and any desired
options; Start the wash cycle by pressing START/Pause button and closing the door within 4 sec.
If it takes more than 4 seconds the appliance automatically pauses and you must restart the appliance again by repeating the last operation.
Adding extra crockery
Without switching off the machine, open the door (START/Pause led starts blinking) (be aware of HOT steam!) and place the crockery inside the
dishwasher. Press the START/Pause button and close the door within 4 sec., the cycle will resume from the point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there is a power cut, the cycle pauses. Press the START/Pause button and close the door within
4 sec., the cycle will resume from the point at which it was interrupted.

Loading the racks

Upper rack
Load delicate and light dishes: glasses, cups, saucers, low salad
bowls.
(loading example for the upper rack)
Foldable flaps with adjustable
position
The side foldable flaps can be fold or
unfold to optimize the arrangement of
crockery inside the rack.
Wine glasses can be placed safely in the
foldable flaps by inserting the stem of
each glass into the corresponding slots.
Depending on the model:
• to unfold the flaps there is needed to
slide it up and rotate or release it from
the snaps and pull it down.
• to fold the flaps there is needed to
rotate it and slide flaps down or pull it
up and attach flaps to the snaps.
Adjusting the height of the upper rack
The height of the upper rack can be
adjusted: high position to place bulky
crockery in the lower basket and low
position to make the most of the tip-
up supports by creating more space
upwards and avoid collision with the
items loaded into lower rack.
The upper rack is equipped with a Upper
Rack height adjuster (see figure),
without pressing the levers, lift it up by simply holding the rack
sides, as soon as the rack is stable in its upper position.
To restore to the lower position, press the levers A at the sides
of the rack and move the basket downwards.
We strongly recommend that you do not adjust the height of
the rack when it is loaded. NEVER raise or lower the basket
on one side only.
Lower rack
For pots, lids, plates, salad bowls, cutlery etc. Large plates and
lids should ideally be placed at the sides to avoid interferences
with the spray arm.
Cutlery basket
The basket is equipped with top grilles for improved cutlery
arrangement. The cutlery basket should be positioned only at
the front of the lower rack. Knives and other utensils with
sharp edges must be placed in the cutlery basket with
the points facing downwards or they must be positioned
horizontally in the tip-up compartments on the upper rack.
When contacting our Service Provider, please state the codes
provided on your product's identification plate.
The model information can be retrieved using the QR-Code
reported in the energy label.
The label also includes the model identifier that can be used to
consult the
https://eprel.ec.europa.eu database portal.
To download the full version visit www.ikea.com
(loading example for the lower rack)
9