Permobil ROHO AGILITY Active Aluminum Back Series Operation Manual page 11

Installation and Height Adjustment
Warnings:
- DO NOT install, remove, or adjust the height of the product
while the individual is seated in the wheelchair.
- After you install the product, and before the individual transfers
into the wheelchair, make sure that all hardware is securely
tightened. Refer to the recommended torque specifications.
Note: The AGILITY Aluminum can be used in a flipped position.
Refer to "Flip the Back Shell" instructions in this manual.
Installation Option A
Use this option if your wheelchair canes do not have push handles or other equipment that may interfere with installation.
1. Before installing the product make sure the hardware is correct
for the wheelchair and back shell. See "Hardware Selection".
2. Loosen, but do not remove, the cane clamp screw. Repeat for
the other side.
Note: If the outer cane clamp becomes detached, see
Installation Option B, step 5.
3. Slide the cane clamps onto the canes to the desired height.
Note: If the product does not fit properly on the wheelchair,
repeat "Hardware Selection".
4. Tighten the cane clamp screws until snug + one-quarter turn.
Note: If a torque wrench is available, tighten to no more than 40
inch-pounds (4.5 Newton-meters).
5. Use a tape measure to make sure the cane clamps are at the
same height.
6. If needed, adjust the height and re-tighten the hardware (see
the previous steps).
Warning: Have the individual safely transfer into the
wheelchair.
PSIS Warning: Make sure that the product is positioned so
that the bottom portion makes contact with the Posterior Superior
Iliac Spine (PSIS). If the product is NOT positioned to make
contact with the PSIS, pelvic support and trunk control may be
reduced.
ROHO AGILITY Active Aluminum Back Series Operation Manual
Follow the instructions for Installation Option A or Installation Option B, depending on your
wheelchair cane type.
9
Option A Option B
PSIS
The 1 in. (2.5 cm) outer
cane clamp is shown.
PSIS