Permobil ROHO AGILITY Active Aluminum Back Series Operation Manual page 7

Hardware Selection Part One: Discs / Screws
Warnings:
- If the wrong hardware is used, the product will NOT fit correctly on the wheelchair. Follow these instructions to select the correct hardware. Consult with a
clinician or the equipment provider for assistance.
- If the product was provided already installed on the wheelchair, it is not necessary to select new hardware. However, if you are going to remove the product
and install it on a different wheelchair, make sure to follow all Hardware Selection and Product Installation and Adjustment instructions before using the
product.
Instructions: Select the correct discs and screws. Then, continue with "Hardware Selection Part Two: Outer Cane Clamps".
STEP ONE: Find the Back Shell
Width.
Refer to the label on the back shell and
the tables below.
Back Shell Width
14
15
16
17
18
14
15
16
17
18
14
15
16
17
18
ROHO AGILITY Active Aluminum Back Series Operation Manual
STEP TWO: Find the correct Width
Range:
Measure the distance between the
outsides of the wheelchair canes, as
shown. Refer to the tables below.
Width Range
cm in.
34.9 - 35.9 13¾ - 141/8
37.5 - 38.4 14¾ - 151/8
40 - 41 15¾ - 161/8
42.5 - 43.5 16¾ - 171/8
45.1 - 46 17¾ - 181/8
cm in.
35.9 - 36.8 141/8 - 141/2
38.4 - 39.4 151/8 - 151/2
41 - 41.9 161/8 - 161/2
43.5 - 44.5 171/8 - 171/2
46 - 47 181/8 - 181/2
cm in.
36.8 - 37.5 141/2 - 14¾
39.4 - 40 151/2 - 15¾
41.9 - 42.5 161/2 - 16¾
44.5 - 45.1 171/2 - 17¾
47 - 47.6 181/2 - 18¾
STEP THREE: Select Option 1, 2, or 3 (based on the Back Shell
Width and the Width Range).
Note: Each Option includes two (2) discs and one (1) screw for each
side of the back shell (total of 4 discs and 2 screws). Set aside any
remaining parts.
L
L
= Left Side
A A
A A
20mm
L
= Left Side
A B
A B
25mm
L
= Left Side
B B
B B
30mm
5
R
Option 1
R
= Right Side
A A
A A
20mm
Option 2
R
= Right Side
B A
B A
25mm
Option 3
R
= Right Side
B B
B B
30mm