ICP DAS USA LC-101H User Manual page 33

#AA000h
#AA0A0h
#AA1c0b
#AAAc0b
%AANNTTCCFF set configuration, NN: new address, TT = 00, CC: new
@AA
@AAh
@AACH
@AACHN
@AACHCN
@AACL
@AACLN
Command
@AACLCN
@AADACN
@AAEATCN
!AAddddd
Set the digital output values, h is a hexadecimal value,
where bit 0 corresponds to DO0 and bit 1 corresponds to
DO1. DO1 is only for LC-102H.
Set the digital output values, h is a hexadecimal value,
where bit 0 corresponds to DO0 and bit 1 corresponds to
DO1. DO1 is only for LC-102H.
Set a single digital output channel, c specifies the channel
0 or 1, b is 0 for off and 1 for on. Channel 1 is only for
LC-102H.
Set a single digital output channel, c specifies the channel
0 or 1, b is 0 for off and 1 for on. Channel 1 is only for
LC-102H.
baud rate
FF: new data format
read the status of digital output and input channels
response
>0O0I, O is digital output status and I is digital input
status
set digital output values, h is a hexadecimal value, where
bit 0 corresponds to DO0 and bit 1 corresponds to DO1.
DO1 is only for LC-102H.
Clear all high latched analog inputs to the current values
Clear channel high latched analog input to the current
value, N = 0 for LC-101H, and 0 or 1 forLC-102H.
Clear high latched alarm of a channel, N = 0 for LC-101H,
and 0 or 1 forLC-102H.
Clear all low latched analog inputs to the current values
Clear channel low latched analog input to the current value,
N = 0 for LC-101H, and 0 or 1 forLC-102H.
Description
Clear low latched alarm of a channel, N = 0 for LC-101H,
and 0 or 1 forLC-102H.
Disable analog input alarm of a channel, N = 0 for
LC-101H, and 0 or 1 forLC-102H.
Enable analog input alarm of a channel, N = 0 for LC-101H,
LC-101H/LC-102H User Manual
-
33 -