Introduction - ICP DAS USA LC-101H User Manual

1. Introduction

The LC lighting control module is easy-to-use and requires no specialist skills to install
and operate, and no software is needed in order to control the lighting control channels.
The LC-101H is a 1-channel lighting control module with AC load current measurement
which provides 1-channel high power relay output and 1-channel AC digital input.
The LC-102H is a 2-channel lighting control module with AC load current measurement
which provides 2-channel high power relay output and 2-channel AC digital input.
The AC load current measurement is provided in the relay control loop. This function not
only allows the user to know the load current value, but also through the measurement
of the load current value, it can be used to know the switching state of the relay, whether
the load is working normally in the light control loop, or the relay is stuck and cannot be
switched.
The input channel can directly control the relay ON and OFF sequence without the host
command.
When required, the module can be communicated with the Modbus RTU protocol, and
an added benefit is that different addresses can be set for Modbus RTU communication
via hardware configuration.
Features
High Power Relay Output to turn ON/OFF the Lighting
Number of lighting fixtures That Can Be Connected:
Incandescent Lamp: 40 W/ 220 VAC * 5 Sets
LED(Electronic ballast): 40 W/ 220 VAC *8 Sets
0 to 5 A AC power Load Current Measurement Relay output
Isolated AC Digital Input
Node Addresses by hardware configuration
Low Power Consumption
Modbus RTU and DCON Protocols
LC-101H/LC-102H User Manual
- 4 -