Advertisement
Installation Key Points (1)
Installing the Enclosure Frame
Open the front door, cut off the cable ties bindi
ng the LCD cable, and disconnect the front door g
round cable. Then lift and remove the front door;
Remove one bolt fastener, two cabinet connecting
plates, and two hinges;
Secure the enclosure frame to the front door fram
e and secure the bolt fastener, cabinet connecti
ng plates, and hinges to the enclosure frame;
Pull the LCD signal cable until the door can be s
moothly opened and closed, install the LCD signal
cable, and put back the NTC cable. Connect the gr
ound cable under the front door to the ground poi
nt marked on the enclosure frame;
Bind the LCD and the NTC cables to the previous b
inding position using cable ties, and install the
front door.
Copyright © 2017 Huawei Technologies Co., Ltd. All rights reserved.
Page 23
Advertisement
