10-3.Function Settings On Wired Remote Controller - Fujitsu ARHG24LMLA Design & Technical Manual

10-3. Function settings on wired remote controller
By using some components on the wired remote controller, you can change the function settings
related on the remote controller.
¢ Component location
Components on the wired remote controller used for the function settings are located as
shown in the following figure.
NOTE: Do not use DIP switch 2.
¢ DIP switch setting
By switching each slide switch on the DIP switch 1, you can change the function settings for
the remote controller.
DIP switch 1
*: Switches are fixed at OFF initially.
• SW2: Dual remote controller setting
Number of remote controller can be changed.
Number of remote
controller
1 (Normal)
2 (Dual)
Front case (back side)
DIP switch 2 DIP switch 1
(All switches are fixed at OFF.)
SW1
SW2
SW3
SW4
SW5
SW6
Primary unit
SW2
OFF
OFF
Indoor unit
1 2 3
1 2 3
Primary unit
Remote controllers
- 31 -
OFF ON
1
2
3
4
5
6
ON
Setting change prohibited*
Dual remote controller setting
Setting change prohibited*
Setting change prohibited*
Setting change prohibited*
Memory backup setting
Secondary unit
SW2
―
ON
Remote controller cable
1 2 3
Secndary
unit
Factory setting
♦