Table of Contents
Advertisement
Locking the Doors
E138637
Press and hold 7·8 and 9·0 at the same
time with the driver door closed.
Note: You do not need to enter the code
first.
KEYLESS ENTRY KEYPAD
PERSONAL ACCESS CODES
Programming a Personal Entry
Code
1.
Enter the five-digit master code.
2. Press 1·2 on the keypad within five
seconds.
3. Enter your personal five-digit code.
You must do this within five seconds
of completing Step 2.
4. Press 1·2 on the keypad to save
personal code 1.
The doors lock then unlock to confirm that
programming was successful.
2022 Expedition (TB8) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Keyless Entry Keypad
(If Equipped)
To program additional personal entry
codes, repeat Steps 1 through 3, then for
Step 4:
•
Press 3·4 to save personal code 2.
•
Press 5·6 to save personal code 3.
•
Press 7·8 to save personal code 4.
•
Press 9·0 to save personal code 5.
If your vehicle comes with SYNC, you can
also program the system with a personal
entry code.
Hints:
•
Do not set a code that uses five of the
same number.
•
Do not use five numbers in sequential
order.
•
The five-digit master code works even
if you have set your own personal code.
Erasing a Personal Code
1.
Enter the five-digit master code.
2. Press and release 1·2 on the keypad
within five seconds.
3. Press and hold 1·2 for two seconds.
You must do this within five seconds
of completing Step 2.
All personal codes erase and only the
five-digit master code works.
Anti-Scan Feature
The keypad goes into an anti-scan mode
if you enter the wrong code seven times.
This mode turns off the keypad for one
minute and the keypad lamp flashes.
The anti-scan feature turns off after:
•
One minute of keypad inactivity.
•
You press the unlock button on the
remote control.
•
You switch the ignition on.
•
You unlock your vehicle using keyless
entry.
86
Advertisement
Table of Contents
Troubleshooting
