Programming The Remote Control - Vehicles With: Push Button Start - Ford Expedition 2022 Owner's Manual

PROGRAMMING THE REMOTE
CONTROL - VEHICLES WITH:
PUSH BUTTON START
General Information
You must have two previously
programmed remote controls inside your
vehicle and the new unprogrammed
remote controls readily accessible. Contact
an authorized dealer to have the spare
remote control programmed if two
previously programmed remotes are not
available. Make sure that your vehicle is
off before beginning this procedure. Make
sure that you close all the doors before
beginning and that they remain closed
throughout the procedure. Perform all
steps within 30 seconds of starting the
sequence. Stop and wait for at least one
minute before starting again if you perform
any steps out of sequence.
Read and understand the entire procedure
before you begin.
Note: You can program a maximum of four
remote controls to your vehicle.
Note: If your programmed remote controls
are lost or stolen and you do not have an
extra coded remote, you need to have your
vehicle towed to an authorized dealer. Store
an extra programmed remote away from
your vehicle in a safe place to help prevent
any inconvenience. Contact an authorized
dealer to purchase additional spare or
replacement remotes.
2022 Expedition (TB8) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Keys and Remote Controls
Steps for Programming Your Spare
Remote Control
Programming Backup Location
E256153
1. Access the backup slot.
2. Place the first programmed remote in
the backup slot with your foot off the
brake pedal, press and release the push
button ignition switch.
3. Wait five seconds and then press and
release the push button ignition switch
again.
4. Remove the remote control.
5. Within 10 seconds, place a second
programmed remote control in the
backup slot. Press and release the
push button ignition switch.
72