Graco 260405 Instructions Manual
  1. Manuals
  2. Brands
  3. Graco Manuals
  4. Industrial Equipment
  5. 260405
  6. Instructions manual

Graco 260405 Instructions Manual

Fuel meter
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Instructions - Parts List
Fuel Meter
For metering fuels.
80 psi (0.55 MPa, 5.5 bar) Maximum Working Pressure
Model 260405, measures in gallons
Model 260414, measures in liters
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
Contents
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Meter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Meter Calibration . . . . . . . . . . . . . . . . . . . . . . . . . 4
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Repair . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Meter Assembly and Disassembly . . . . . . . . . . . . 5
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Graco Standard Warranty . . . . . . . . . . . . . . . . . . . 10
Graco Information . . . . . . . . . . . . . . . . . . . . . . . . . 10
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2005, Graco Inc. is registered to I.S. EN ISO 9001
311309 rev.B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 260405 and is the answer not in the manual?

Questions and answers

Related Manuals for Graco 260405

Summary of Contents for Graco 260405

  • Page 1: Table Of Contents

    Graco Standard Warranty ....10 Graco Information ......10 Graco Inc.

  • Page 2: Warnings

    Warnings Warnings The following general warnings are for the setup, use, grounding, maintenance, and repair of this equipment. Additional, more specific warnings may be found throughout the body of this manual where applicable. Symbols appearing in the body of the manual refer to these general warnings. When these symbols appear throughout the manual, refer back to these pages for a description of the specific hazard.
  • Page 3 Graco replacement parts only. • Do not alter or modify equipment. • Use equipment only for its intended purpose. Call your Graco distributor for informa- tion. • Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

  • Page 4: Installation

    To rotate the counter assembly (16), see steps 2-3 under Meter Assembly and Dis- assembly, page 5. Rotate the counter The 260405 registers the fluid in gallons. The assembly so that the number wheels are top (larger) number wheel can be reset to zero horizontal.

  • Page 5: Repair

    (7) and washers (6). Disk parts Disassembly must be replaced as an assembly; order kit number 260429 for model 260405 (gallons) To replace any of the major assemblies, disas- and kit number 260430 for model 260414 semble meter as follows. See Parts, page 8.

  • Page 6: Troubleshooting

    Troubleshooting Troubleshooting Problem Cause Solution Meter runs in reverse. Meter installed backward. Install meter with port marked “inlet” to pump outlet. Fluid leakage in counter. Seal on counter input shaft Replace counter assembly. leaking. Dust and dirt in counter cover. Cover seal (8) or knob seal Install missing seal, or correct (10) missing or improperly installation.
  • Page 7 Troubleshooting 311309B...

  • Page 8: Parts

    Parts Parts Models 260405, 260414 Ref. Ref. No. Description Qty. No. Description Qty. 10 SEAL, grommet 1 HOUSING, meter 11 SCREW; 8-32 x 1/4 in. 2 SEAL, o-ring 14 HOUSING, counter, cover 3 CHAMBER, lower 15 HEX BOLT; 1/4-20 x 3/4 in.

  • Page 9: Technical Data

    Technical Data Technical Data Working Pressure 80 psi (0.55 MPa, 5.5 bar) Inlet Size 3/4 in. npt Outlet Size 3/4 in. npt Weight 2.5 lb (1.1 kg) Wetted Parts diecast aluminum, carbon steel with zinc plat- ing, 12L14 steel with zinc plating, 416 stainless ®...

  • Page 10: Graco Standard Warranty

    With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.

This manual is also suitable for:

260414

Table of Contents