Toshiba e-STUDIO 2010AC Operator's Manual page 41

4.TopAccess
Item name
9 Connection MFP
10 Use Common Settings
11 Use Separate Settings
12 [Add] button
13 [Delete] button
14 Connection MFP entry field
15 Server Address
16 [Connect] button
17 [TopAccess] button
18 Group Connection Enable
19 Own Group Name
Specify the following communication settings for the multi station print.
 Port Number — Enter the port number.
 Enable SSL/TLS — Select the SSL/TLS setting for the multi station print.
- Disable — Select this to disable SSL/TLS.
- Verify with imported CA certification(s) — Select this to use CA
certificates for connection. You need to export the certificate from each
MFP and import it into all MFPs.
- Accept all certificates without CA — Select this to accept all certificates
without CA. There is no need to import the certificate of each MFP.
 Authentication — Select [Disable] or [Basic] for authentication. [Disable] is
set as the default.
 User Name — Enter the user name. You can enter up to 127 alphanumerical
characters and symbols except = ; # @ \.
 Password — Enter the password of the user. You can enter up to 127
alphanumerical characters and symbols except = ; # \.
All MFPs should have the same settings for the connection.
Although the multi station print is available even if the user authentication is
disabled, this MFP cannot be connected to other MFPs: the job list is not
shared.
Uses information of the MFPs registered on the [Common Settings] screen to
update the following list automatically: you cannot change the list. The
[Connection] and [TopAccess] buttons are not available for your own MFP.
Uses information of the MFPs registered in the following list.
Allows you to add the device to connect.
Allows you to delete the selected device.
Enter the IP address or host name of the MFP you want to register.
If the user authentication is disabled with more than one address registered in
the [Connection MFP] list, the [Connection MFP] settings are not displayed.
Shows the IP address or host name of the registered MFP.
Tests the connection with the specified MFP to check if the communications
can be established.
Be sure to save the Multi Station Print settings with the [Save] button before
you test the MFP connection with the [Connect] button.
Starts TopAccess.
Select whether to connect the MFP groups. [Disable] is set as the default.
Enter a group name to which this MFP belongs. You can enter up to 12
characters.
All groups should share the same name of each group for the connection.
Description
[Administration] Tab 41