Toshiba e-STUDIO 2010AC Operator's Manual page 13

3.User Functions
Item name
Secure Receive
Forced Setting
RTI for G3
TTI for G3
ECM for G3
Multi Dest.
Confirmation
Preview Setting
Tx Speed Limit
Rx Speed Limit
Default Address Book Select the default tab displayed in the address book.
Default View for
Single
You can enable or disable the Secure Receive function. This is available only when the
Weekly Schedule function is set.
 Enable — This enables the Secure Receive function.
It becomes disabled at the time set by Weekly Schedule.
 Disable — This disables the Secure Receive function.
 It becomes enabled at the time set by Weekly Schedule.
 An administrator password is required.
Switch the RTI recording On or Off for G3 fax. To enable this feature, the Terminal ID
must be registered to this equipment in advance.
Switch the TTI recording On or Off for G3 fax. To enable this feature, the Terminal ID
must be registered to this equipment in advance.
Setting this item may not be required since it may not be displayed on the screen (it
depends on your country or region).
Switch the ECM (Error Correction Mode) communication On or Off for G3 fax.
ECM is an internationally standardized communication mode that automatically
corrects errors that occur during fax transmissions. With this setting option ON, even
when the transmitted data have been affected by noise during communication, this
mode allows good communication without image distortion by automatically
resending the part that have been affected.
 Both the sender and the receiver must have the ECM function to make ECM commu-
nication available.
 When affected by noise during communication, communication time is slightly lon-
ger than usual. Even when the ECM communication is used, an error may occur
depending on the line status.
 The ECM communication is not available for voice communication.
Select whether to display the confirmation screen when multiple destinations are
specified.
Enabling the Preview function allows you to preview the scanned image before
transmitting the fax/Internet Fax job.
 On — Press this button to enable the function.
 Off — Press this button to disable the function.
The transmission with V.34 may fail depending on the communication quality of your
line. Transmission failures may be avoided when this setting is set to On.
The reception with V.34 may fail depending on the communication quality of your line.
Reception failures may be avoided when this setting is set to On.
 Line 1 — Selects whether to enable the Rx speed limit for the 1st line.
 Line 2 — Selects whether to enable the Rx speed limit for the 2nd line.
Select the default display format for the single tab of the address book.
Description
User 13