LG ARVU053ZEA2 Engineering Manual page 33

INSTALLATION AND LAYOUT BEST PRACTICES
Table 6:Installer Setting Codes and Values Table
No.
1 Setting Address of Central Control
2 Supply ESP
3 Exhaust ESP
4 Product direction
5 Quick Refresh Priority
6 Master setting
7 Dry Contact Auto
8 Release of 3 Min Delay
Setting Address of Central Control
1. When connecting central control, it sets the central control address of the indoor unit.
2. Function control and setting
• Select the address code with inputting the up-down button (0~ F).
• Change the items with inputting the right-left button. (Group address <-> indoor unit address)
• Set the address with inputting Setting/Cancel button (indoor data send)
Supply/Exhaust ESP Setting
1. Set the E.S.P (RPM) value of the air conditioner unit.
2. Function control and setting
• Select the wind strength with inputting up-down button.
• 01:low, 02:high, 03:very high (Seg flickering)
• Move the setting items with inputting the right-left button.
• Airflow selection <-> RPM value selection (Seg of selected item is flickering)
• Select the RPM value of airflow with inputting up-down button.
• 0
~ 255 (Seg selecting)
• Complete the RPM setting with inputting Setting/Cancel button (send RPM setting data of indoor unit).
• Set the exhaust air ESP with conducting the steps above and inputting the function setting button and changing installer code to 04.
Product Direction
1. Set the installation direction of the ventilation for the indoor unit.
2. Function control and setting
• Select the direction value with inputting the up-down button.
• 01:normal direction, 02:opposite direction
• Complete the setting with inputting Setting/Cancel button (stop flickering and send the date to the indoor unit).
Function Code
01
02
03
04
05
06
07
08
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Value
00~FF : Address of central control
Value1 - Step(01:low, 02:high, 03:super high)
Value 2 - ESP value (0 ~ 255)
01: Normal, 02:Reverse
00:Slave, 01:Master
00:OFF, 01:ON
01:Set
33