Leds On Battery - Stihl TSA 230 Instruction Manual

12 LEDs on Battery

3
The LED (3) on the charger comes on when the
battery is inserted – see "LED on Charger"
Charging begins as soon as the LEDs (4) on the
battery glow green – see "LEDs on Battery".
The charge time is dependent on a number of
factors, including battery condition, ambient tem‐
perature, etc., and may therefore vary from the
times specified.
The battery heats up during operation in the
power tool. If a hot battery is inserted in the
charger, it may be necessary to cool it down
before charging. The charging process begins
only after the battery has cooled down. The time
required for cooling may prolong the charge time.
The battery and charger heat up during the
charging process.
11.1 AL 300, AL 500 Chargers
The AL 300 and AL 500 chargers are equipped
with a battery cooling fan
11.2 AL 100 Charger
The AL 100 charger has no fan and waits for the
battery to cool down before starting the charging
process. The battery is cooled by heat transfer to
the ambient air.
11.3 End of Charge
The charger switches itself off automatically
when the battery is fully charged:
– LEDs on the battery go off.
– The LED on the charger goes off.
– The charger's fan is switched off (if charger is
so equipped)
Remove the fully charged battery from the
charger.
0458-707-9821-C
4
12 LEDs on Battery
Four LEDs show the battery's state of charge
and any problems that occur in the battery or
machine.
► Press button (1) to activate the display – the
display goes off automatically after 5 seconds.
The LEDs can glow or flash green or red.
LED glows continuously green.
LED flashes green.
LED glows continuously red.
LED flashes red.
12.1 During charging
The LEDs glow continuously or flash to indicate
the progress of charge.
A green flashing LED indicates the capacity that
is currently being charged.
English
1
51