Pentax K10D Operating Manual page 128

126
5
Under the light to adjust the white balance, fully display a
white sheet of paper in the viewfinder or select a white
area as the subject.
6
Press the shutter release
button fully.
Slide the focus mode lever to \
when the shutter cannot be released.
The screen to select the measuring
range is displayed.
7
Use the rear e-dial to select the entire screen or spot area
4
for the measuring range.
Proceed to Step 9 if the entire screen is selected.
8
Use the four-way controller (2345) to move the frame
to the area you want to measure.
9
Press the 4 button.
The White Balance fine-tuning screen
appears when measuring is completed.
Tune using steps in "Fine-Tuning the
White Balance" if fine-tuning is
necessary. (p.123)
10
Press the 4 button.
The camera returns to the White Balance screen.
11
Press the 4 button twice.
The camera is ready to take a picture with the set White Balance.
• No image is recorded when the shutter release button is pressed to adjust
the white balance.
• [NG] appears when measuring is unsuccessful. Press the 4 button while
displayed to return to the White Balance fine tune screen.
• If the picture is extremely overexposed or underexposed, white balance may not be
adjusted. In this case, adjust appropriate exposure and adjust the white balance.
Manual Manual Manual
White Balance White Balance White Balance
SHUTTER
B B
±0 ±0 ±0 ±0
Cancel Cancel Cancel
±0 ±0
MENU
OK OK OK
OK
G G
A A A
M M
OK OK OK
OK