Attaching The Embroidery Hoop To The Machine - ELNA eXpressive 850 Instruction Manual

q
w
r
Attaching the Embroidery Hoop to the
Machine
Turn the power switch on and open the carriage arm.
Press the mode switch key and a warning message will
appear.
Press the OK key and the carriage will move to the
starting position. The feed dog is lowered automatically.
The visual touch screen will display the embroidery mode
window.
q Mode switch key
NOTE:
The drop feed lever will shift as the feed dog is lowered.
NOTE:
If you press the mode switch key with the carriage arm
retracted, a confirmation message will appear.
Do not press the OK key or X key. Instead, open the
carriage arm.
Place the hoop on the machine and attach the hoop to
the carriage by inserting the lock pin of the hoop into the
hole in the carriage.
Turn the knob clockwise to secure the hoop.
w Lock pin
e Hole
e
Thread holder
To avoid sewing over a tail of the needle thread, place the
thread end on the thread holder.
r Thread holder
Pass the needle thread through the hole in the
embroidery foot and draw it up to the thread holder.
Hang the thread on the thread holder from front to back.
93