Maintenance; Waste Electrical And Electronic Equipment (Weee); Warranty - VETEC V-LINK WRDX01 User Instructions

8.2. Regulatory audit / recalibration
V-link dynamometers are as standard supplied with a certifi cate of test and calibrati-
on which is valid for one (1) year.
The certifi cate indicates the values obtained during the adjustment. A new certifi ca-
te of test and calibration will be issued every time a calibration is conducted.
An annual check of each device is recommended.

9. Maintenance

V-link requires no maintenance except regular cleaning after each use.
- Wipe off moisture or dust using a slightly damp, clean cloth.
- Cover the exterior with a thin layer of oil, e.g. WD 40. This will prevent rust.
- Keep the V-link in a dry, clean place.
- Never use cleaning solutions or high-pressure water.

10. Waste electrical and electronic equipment (WEEE)

11. Warranty

Our products are warrantied for defects in materials or workmanship for a period of
one (1) year from the date of purchase.
In the event of a defect during the warranty period, the dynamometer must be re-
turned, with freight (and all duties and taxes) prepaid by the Buyer. Vetec A/S or the
distributor will, according to their choice, repair or replace the defective unit.
The following faults are not covered by the warranty:
- Faults resulting from normal wear and tear.
- Parts of a consumable nature.
- Products that have been subject to unauthorized modifi cations.
- Faults resulting from incorrect installation or use.
- Damp or water damage exceeding the IP classifi cation.
A V-link must not be thrown away with general rubbish.
Any disposal of the device must be carried out in accor-
dance with the regulations in force in the country of use.
Contact your local government's recycling or solid waste
department for more information regarding the proper
disposal of electronics in your region.
- 32 -