Charging; Service, Repairs And Maintenance; Battery Replacement; Regulatory Audit / Calibration - VETEC V-LINK WRDX01 User Instructions

7. Charging

V-link is charged using a standard high quality USB charger. Always on stock at
Vetec or available in any store.
Charge the dynamometer in your car, connected to your computer or using a wall
charger.
As the charger is not waterproof charging the unit in a safe dry place is recommen-
ded. Place the dynamometer on a stable surface and make sure it is turned off.
Plug in and charge up using the USB port on the rear of the dynamometer.
Charge temperature 0°C to 45°C. A fully discharged battery takes up to 6 hours to
recharge.

8. Service, repairs and maintenance

To prevent damage to the dynamometer, make sure that repairs and recalibration
are carried out by qualified personnel.
It is recommended that recalibration and repairs are done at Vetec's service de-
partment located in Denmark or by authorized partners. Contact Vetec's service
department for further information.
When you return a dynamometer for repair, make sure to always include the invoice
number or the delivery note along with a description of the problem.

8.1. Battery replacement

The battery indicator blinks when it needs to be replaced. It is recommended to
contact Vetec's inhouse service department in order to sustain warranty and safety
certificates.
International service tasks are usually carried out within a week.
Contact Vetec at 0045 65905802 or post@vetec.dk.
- 31 -