Connect Remote Display And Weighing Unit - VETEC V-LINK WRDX01 User Instructions

2.2. Connect remote display and weighing unit

Your products should always have the latest software (Version 4.26 or later)
Turn on both units. Press and hold the MENU button on the remote display. Go to
"4" by pressing the arrow buttons, then press ENTER.
Type in the 8 digit serial number. If the serial number has more than eight digits
then type in the last 8 digits. If your serial number is less than 8 digits, type in a "0"
before entering the 7 digits of the serial number.
Use the arrow buttons
If you exceed "9" when typing in the digits, be aware that the digit to the left will go
up. Complete entry by pressing ENTER.
The display will now show "NO CO". Turn on the unit by pressing and holding the
ON/OFF button.
Turn the unit on again. The unit are now connected and are ready to use.
/ to change the digits. Go to next digit by pressing

- 25 -
   
.
 