Duration Setting; Alarm Sign Setting - Sanyo VCC-P7575PA Instruction Manual

DURATION setting

1
Select "DURATION" and specify the duration for
the alarm sign indication (a time until next alarm
input becomes enabled).
·DURATION
• Select from: 5S, 10S, 15S, 20S, 30S, 1M, 2M, 3M, 4M, 5M
(S = second, M = minute)
Note: You should not specify shorter "DURATION" than "ZOOM TIME".
Otherwise, "ZOOM TIME" setting will change correspondingly.
Confirm both times before specifying proper values.
2
Set "MENU" to "END" and press the SET button.
RFinishes the settings screen and returns to the normal
monitoring screen.
• If you want to return to the previous screen, select "BACK" and
press the SET button.
ALARM SETTING
ALARM IN
NO
MOTION
ON
uAREA SET y
uSENSITIVITY
SET y
ZOOM OFF
uZOOM TIME
5S
·DURATION
5S
ALARM SIGN OFF
PRESET
OFF
MENU BACK
Specifying Alarm Input <ALARM>

ALARM SIGN setting

1
Select "ALARM SIGN" and specify "ON".
·ALARM SIGN ON
ON : When an alarm signal is input, the camera name on the
screen will blink during the time that has been set in
"DURATION".
When masking setting is "ON", "A" will be displayed on all
specified masking positions.
Alarm sign indicates when motion sensor is detected (See
page 29).
OFF : The alarm sign is unused.
2
Set "MENU" to "END" and press the SET button.
RFinishes the settings screen and returns to the normal
monitoring screen.
• If you want to return to the previous screen, select "BACK" and
press the SET button.
ALARM SETTING
ALARM IN
NO
MOTION ON
uAREA
SET y
uSENSITIVITY
SET y
ZOOM
OFF
uZOOM TIME
5S
DURATION 5S
·ALARM SIGN
OFF
PRESET OFF
MENU
BACK
32