Advertisement
In-ceiling Mount (Open Type)
Make sure to also consult the In-ceiling Bracket Open Type Instruction Manual.
1. Installing the power board unit
1 Draw a circumference on the ceiling using the
supplied drop-prevention cable (A) as compass, and
drill a hole for installing the in-ceiling bracket.
2 Pull out the cables from the ceiling.
3 Pass the supplied screws (B) through each of the
power board unit screw holes and fasten them
loosely using washers (4 places).
4 Mount the power board unit in the in-ceiling bracket.
Tighten firmly the screws (B) loosely fastened in the
previous step.
● When inserting the power board unit, do it diagonally.
2. Installing on the ceiling
5 Attach the supplied safety wire (C) to the ceiling
beam, for example, then connect it to the bracket-top
hole (D).
6 Connect the video cable and pass the connection
cables through the bracket.
7 Insert the bracket into the ceiling hole and fix it
using screws (E) (2 places).
8 Connect the cables and set the switches.
☞ See "Connections and Settings" on page 5.
9 Align the blue sticker (F) on the bracket and the
arrow (F) of the same color on the camera unit, and
then push the camera unit until they click.
F Align the SANYO logos on the supplied bracket
cover and the bracket, and push the cover until they
click.
■ How to attach the drop-prevention cable
(accessory)
Fasten the drop-prevention cable (A) to the hooks (G) on
the bracket and its cover, then slide the cable as shown in
the figure.
G
A
Accessories
Screw, washer
(for power board unit)
Safety wire
G
Drop-prevention
cable
Bracket cover
φ192 mm (7.6")
A
2
7
6
E
9
– 4 –
1
3
3
3
B
C
5
D
D
E
7
8
E
F; Blue
To remove the camera unit
F
3
4
C
5
E
Advertisement
