Advertisement
Available languages
Available languages
▪ Be aware that heat may be conducted to combustible materials that are out of sight.
▪ Please note that poisonous gases may be emitted while removing paint. Use suitable
inhalation protection and ensure adequate ventilation.
▪ Keep the air slots and the nozzle clean to avoid overheating the unit and to prevent from
fire hazard.
▪ Use original accessory only.
▪ Should the unit become damaged do not use it any further and have it repaired by a
professional or contact our customer service. Do not disassemble the unit or try repairing
it yourself. Please read this manual carefully and use the unit only according to this manual.
▪ When using the tool, use safety equipment including safety glasses and ear protection. If
operating the tool causes discomfort in any way, stop immediately and review your method
of use.
▪ Dispose of used packaging material carefully or store it out of the reach of children. There
is a danger of suffocation!
▪ Persons with limited physical, sensorial or mental abilities are not allowed to use the unit,
unless they are supervised and briefed for their safety by a qualified person.
▪ Battery chargers are for indoors use only. Ensure that the power supply and charger are
protected against moisture at all times.
▪ Use metal and voltage detectors to locate concealed electric, water or gas lines. Avoid
touching live components or conductors.
▪ Ensure that the lighting is adequate.
▪ Ensure that the drill bit is securely fixed in the chuck. Insecure drill bits can be ejected
from the machine causing a hazard.
▪ Ensure that the drill bit is in contact with the workpiece prior to starting up the tool.
▪ Before drilling, check that there is sufficient clearance for the drill bit under the
workpiece.
▪ Do not exert pressure on to the tool. To do so would shorten its lifetime.
▪ Drill bits get hot during operation; allow cooling prior to handling them.
▪ Never use your hands to remove sawdust, chips or waste close by the bit.
▪ If you are interrupted when operating the cordless drill, complete the process and
switch off before looking up.
▪ If possible, use clamps or a vice to hold your work.
▪ Examine the chuck regularly for signs of wear or damage. Have damaged parts repaired
by a qualified service centre.
▪ Always wait until the cordless drill has come to a complete stop before putting it down.
▪ Periodically check all nuts, bolts and other fixings and tighten where necessary.
▪ Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Batteries do not belong in the household garbage.
For battery disposal please check with your local
council.
14
Advertisement
