Installation & Operation; Installation Instructions - FRIGOGLASS Super-5 [R600a] Manual

ENG
4. Installation & operation
4.1

Installation instructions

i. In case the cooler is packed by the full face packaging, after unpacking, you need to remove
carefully the protective films that are stuck on the door profiles.
ii. After unpacking, check the cabinet for any damage caused during transportation. In the event of
damage, please contact the forwarding company.
iii. Always ensure that your merchandiser is installed on a stable surface/floor. There are adjustable
feet at the front, under the chassis. The cooler must be leveled through proper adjustment of the
leveling feet in all installations. It must be ensured that the cooler does not exhibit any inclination
towards its front side and/or its lateral sides, after adjustment. A slight inclination toward its back side
will further facilitate the good circulation of the fluid and support the door closing mechanism. The use
of a spirit level is highly advisable to check leveling. Verify that the cooler sits firmly on the leveling feet.
The front cooler wheels (if available) should be able to rotate by hand after cooler installation and
adjustment. There are 2 or 3 (depending on the size) adjustable feet for all models at the front under
the chassis. The level foot must be adjusted in such a way that the lower edges of the internal cabin
are aligned. The below given check points must be on the same line.
When the cooler has small rotating castor wheels (optional feature) the brake must always be applied
when cooler is at the final position.
8
Failure to comply with the instructions may result in high-energy
consumption, poor performance of the unit and void warranty.