Care & Cleaning - FRIGOGLASS Super-5 [R600a] Manual

The PRCD device is integrated to the power cord of the unit (as shown in picture below), close to the
wall plug.
The PRCD device features two buttons; the small one is the "test" button and is used to check the
operational status of the PRCD. The bigger button is the "reset" and is used to rearm the PRCD after a
triggering event.
When plugging off the power cord a test needs to be perfomred to ensure proper operation of the
PRCD. Please follow the steps below:
Step 1: Plug into power.
Step 2: Press (small) "TEST" button. The (big) "RESET" button should pop-up.
Step 3: Press the "RESET" button again. Do not use the device if it fails!
9. Care & cleaning
It is important to clean the merchandiser twice a year. In order to avoid mould formation, odours, etc.
product compartments must also be thoroughly cleaned. The interior of the ICM should be cleaned
with a mildly soapy cloth and the glass surface using a window-cleaning agent.
Other series (RCCB is covered by plastic
cover and located in cooling mechanism are)
PRIOR TO ANY CLEANING (INSIDE OR OUTSIDE THE DEVICE)
PROCEDURE, UNPLUG THE ICM! REMOVE THE PLUG AND MAKE SURE
THAT THE OPERATOR CAN CHECK FROM ANY OF THE POINTS WHICH
HE HAS ACCESS THAT THE CABLE IS UNPLUGGED.
ENG
15