Analog Devices iSensor ADIS/EVAL/USB Preliminary Technical Data page 11

Preliminary Technical Data
1
2
3
FIGURE FLAG NOTES:
1. Perform a single read of the ADIS16203's output data
2. Start and stop continuous reading of the ADIS16203's output data. Set the acquisition loop delay time. This provides rough
control over sample times. Please note that this data will not have a high degree of coherence.
3. Select the file data logging option.
4. Configure the ADIS16203's internal sample rate and filter response.
5. Graphical orientation. Note that for incline angle - 0°, the corner dot would be in the lower, left hand corner.
6. Alarm monitoring. Note that these turn red on alarm condition. They maintain their status until the Reset button is pressed,
even if the error condition has cleared.
5
6
Figure 17. ADIS16203 Evaluation Software
Rev. PrD | Page 11 of 13
ADISEVAL/USBZ
4